Gravity BTP-S80 Logo programming

S80 Logo Programming

Download and install Printer Utility 1.1.2.7.

I:\Common\Software\Printing\BTP-S80\PrinterUtility_WIN_V1.1.2.7.tar

Select Device: BTP-S80

Select Connection method and turn On. (network in this example, manual enter IP or search)

For a new printer: default IP is 192.168.1.251, to change either use browser BUI or the utility v1.66.

I:\Common\Software\Printing\BTP-S80\S80.zip

Click on the grey +and select the logo.

Select: Mono and Flash then click DOWNLOAD.

Once downloaded click print and after a short delay the logo will print.

** If you receive errors such as Flash Full or cannot download image, run the v1.66 utility, Eeprom Set and select Set Factory Default Setting. Also check that Cutter Type is set to Partial.